DAVIS Wireless Repeater 7625 Instrukcja Instalacji Pobierz pdf (Strona 13)

Mounting the Anemometer Transmitter Page 13

Mounting Transmitter Shelter on a Vertical Surface

1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a

carpenter’s level to ensure the holes will be level.

2. Drill two more holes 7-1/32" below the upper holes.

MOUNTING TRANSMITTER SHELTER ON A POST

3. Insert the 1/4" x 1-1/2" lag screws through the ﬂat washers, and through the holes at

the top of the shelter into the post.

Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

4. Insert the 1/4" x 1-1/2" lag screws through the ﬂat washers, and through the holes at

the bottom of the shelter into the post.

Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

Flat

Washer

Lag

Screw

1 2 ... 8 9 10 11 12 13 14 15 16

Brak uwag

DAVIS Wireless Repeater 7625 Instrukcja Instalacji Strona 13