DAVIS Sensor Mounting Arm Instrukcja Użytkownika Pobierz pdf (Strona 11)

Attaching the Anemometer Page 11

10. Slide the anemometer arm backwards/forwards until the end of the anemometer arm

extends just 1/2” past the second U-bolt/saddle.

POSITION ANEMOMETER ARM

11. Once the anemometer arm is correctly positioned, tighten the hex nuts.

In order to keep the anemometer arm steady in high winds, tighten the hex

nuts until you notice the anemometer arm just begin to buckle underneath

the U-Bolt.

12. Place a cable clamp around the anemometer cable.

13. Slide a #8-32 x 3/4”screw down through the indicated hole on the sensor arm.

ATTACH THE CABLE CLAMP

14.Run the anemometer cable underneath the sensor arm and slide the hole in the cable

clamp over the end of the #8-32 x 3/4” screw.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

DAVIS Sensor Mounting Arm Instrukcja Użytkownika Strona 11